装载机轮胎防护链如何安装？

装载机轮胎防护链是金属材料制成的，安装在轮胎上的网状防护装置，可以有效的保护装载机的轮胎，不被尖锐的石块等伤害，延长了轮胎的使用寿命。装载机轮胎防护链的安装所需工具：锤子、钳子、铁丝。
The loader tire protection chains are made of metal material, mesh protective device installed on the tire, can effectively protect the loader tires, not by sharp stones and other damage, prolong the service life of the tire. Loader tyre protection chain installation tools: hammer, pliers, wire.

把装载机放在平坦地段，将轮胎的气放出三分之一左右；将装载机链条展开、铺平在需要装的轮胎的正前方；将配件取下，用1米左右的铁丝挂住链条的一端；开动装载机，注意轮胎正面与链条正面对齐；用铁丝挂住装载机轮胎的花纹，用撬棍摆正链条，车辆缓缓向后移动，直到保护链将轮胎裹全为止；链条两端对好后，用连接节连接两端即可；串好装载机轮胎外侧的收紧链，并调试收紧；检查装载机整个轮胎保护链的锁紧环，使其焊口朝外，以免磨损轮胎。
The loader on the flat area, the tire gas released about 1/3; in front of the loader chain expansion, paved in need to install tires; the parts removed, by the end of 1 meters of wire on the chain; start the loader, pay attention to positive and positive tire chain alignment; loader tire the wire on the pattern, with a crowbar to straighten out the chain, the vehicle slowly moving backwards, until the tire protection chains wrapped all so far; the chain ends of after connecting section is connected on both ends; the outer side of the tire loader to tighten the chain, and check the whole debugging tightened; loader tire protection chain lock ring, the the weld outward, so as not to tire wear.